Top > MAINTENANCE > Cleaning > Cleaning the Air Filter(Glaze Type)

Cleaning the Air Filter(Glaze Type)

Warning

  • Wear gloves during the work.

  • Before cleaning or performing maintenance, disconnect the power supply and wait until the fan stops.

Caution

  • When you remove the air filter, do not touch the metal parts of the indoor unit. Doing so may cause an injury.

  • Do not bend the air filter, as it may break.

  • Assemble the air filter properly to prevent dust and other substances from entering the product.

Removing the Filter

  • Open the front grille by pulling the both sides of it.

    • The arrows are marked on both sides of the front grille.

  • Remove the air filter by pushing the knobs on it.

  • Remove the PM1.0 filter by pressing the knobs on it.

    Warning

    • Don't touch the PM1.0 Filter within 10 seconds after opening the front grille.

      • Unless, it may cause an electric shock.

  • After pushing down the ring, remove the deodorization filter.

Cleaning the Air Filter

  • Clean the air filter with a vacuum cleaner or wash it with lukewarm water and a mild detergent.

  • Dry the filter in the shade.

Cleaning the PM1.0 Filter and Deodorization Filter

PM1.0 Filter

  1. Soak the PM1.0 filter in enough water to submerge it and shake it several times to clean it.

    • Clean the filter without disassembling it.

    • If it is heavily soiled, soak it in lukewarm water with neutral detergent for 30 minutes, then rinse thoroughly with clean water.

  2. Dry in the shade for about a day.

    • If you assemble the PM1.0 filter with moisture remaining, 7 beeps will sound.

Caution

  • Do not use hot water over 40 \ or volatile liquids.

  • Do not use acidic detergents such as citric acid.

  • Drying with a hot air heater, such as a hair dryer or a heater, could damage or deform the filter.

  • The inside of the filter is sharp, so do not rub or touch it directly.

Deodorization Filter

Do not wash the deodorization filter with water and dry for about 3 hours under weak sunlight or fluorescent light.

  • Washing the filter with water could damage or deform it.

Mounting the Filter

  • After pushing down the ring, insert the deodorization filter.

  • Insert the PM1.0 filter.

  • Insert the air filter.

  • Close up the front grille and fix it by pushing the centre and both sides of it.

    • The arrows are marked on both sides of the front grille.