Cleaning the PM1.0 Sensor
This process is applicable only when the PM1.0 sensor is installed.
Disconnect the power supply to the appliance before work.
When cleaning the sensor, be careful so as to avoid falling accidents.
When removing the sensor corner cover, be careful not to drop the product.
Put your finger in the indicator.
Open the front grille and pull down the PM1.0 sensor case.
Lower the PM1.0 sensor case all the way down and rotate the dust sensor case to fix it.
Open the PM1.0 sensor cover on the side of the case.
Wipe off any dust adhering to the lens using a cotton swab slightly moistened with water. Then wipe again with a dry cotton swab to remove all remaining moisture.
Close the PM1.0 sensor case, then install the PM1.0 sensor case into its original position.
It is recommended to clean the PM1.0 sensor every 6 months.(assuming 8 hours of daily use)
PM1.0 Sensor is only included with air purification panel.
The features can be different depending on the model.