Air conditioner does not start.
The air conditioner is unplugged.
Make sure the air conditioner plug is pushed completely into the outlet.
The fuse is blown/circuit breaker is tripped.
Check the house fuse/circuit breaker box and replace the fuse or reset the breaker.
Power failure.
If power failure occurs, turn the mode control to off. When power is restored, wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload.
The current interrupter device is tripped.
Press the RESET button located on the power cord plug. If the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.
Air conditioner does not cool as it should.
Airflow is restricted.
Make sure there are no curtains, blinds, or furniture blocking the front of the air conditioner.
The temp control may not be set correctly.
Set the target temperature to a level lower than the current temperature.
The air filter is dirty.
Clean the filter at least every 2 weeks. See the MAINTENANCE section.
The room may have been hot.
When the air conditioner is first turned on, you need to allow time for the room to cool down.
Cold air is escaping.
Check for open fumace floor registers and cold air returns.
Cooling coils have iced up.
See ‘Air conditioner freezing up’ below.
Air conditioner freezing up.
The cooling coils are iced over.
Ice may block the airflow and obstruct the air conditioner from properly cooling the room. Set the mode control at High Fan or High Cool.
Water drips outside.
Hot, humid weather.
This is normal.
Water drips Indoors.
The air conditioner is not tilted to the outside.
For proper water disposal, make sure the air conditioner slants slightly from the cabinet front to the rear.
Water collects in base pan.
Moisture reduced from air and drains into base pan.
This is normal for a short period in areas with little humidity; normal for a longer period in very humid areas.
Air conditioner turns on and off rapidly.
Dirty air filter - air restricted.
Clean air filter.
Outside temperature extremely hot.
Refer to installation instructions or check with installer.
Noise when unit is cooling.
Air movement sound.
This is normal. If too loud, set to lower fan setting.
Window vibration - poor installation.
Refer to installation instructions or check with installer.
Room too cold.
Set temperature too low.
Increase set temperature.
Remote sensing deactivating prematurely.
Remote control not located within range.
Place remote control within 20 feet & 120° radius of the front of the unit.
Remote control signal obstructed.
Remove obstruction.